LERDGE 3D Printer Board ARM 32Bit Controller Motherboard 3.5 inch Kit Diy parts mainboard PT100 TMC
[32924347991] Only K Board:（NO DRIVERS,NO3.5-INCH TOUCH SCREEN ） If you already have a driver modules, you already have a 3.5-inch touch screen, you canbuy Only K Board. Tip: The Lerdge K motherboard have to match with our 3.5-inch touch screen to be used. The Lerdge Kmotherboards are not compatible with the touch screen of the old version of the Lerdge S motherboard. Applicable model： XYZ(Ultimaker、Makerbot)、Detla、CoreXY(Hbot) and CoreXZ About power continued to play function: Lerdge-K motherboard comes with printing pause, printing save, and start-up function. But if you need the function of saving power and continue to play when power off unexpectedly, and the function of automatically turning off after the printing finished, apower monitoring moduleis needed. About printing instructions: The Lerdge-K motherboard defaults to offline printing (UseTF card printing or U disk printing). If need the online printing, an online moduleis needed. About the use of heated bed: The heated bed with a power of no more than 150w can be connected directly to the motherboard. If the heated bed power is too large, please use ahigh-power MOS hot bed module. For large-size machines, if you need to connect externally, please purchase an external driveadapter moduleto drive a larger motor, such as 57 motor, 86 motor, etc. The motherboard itself is recommended to drive 42 motor. As shown in the figure below.
US $74.00Grab Now 30% US $51.80
Tidak ada komentar:
Posting Komentar